video issue

[bossgp]

Just thought I would ask this question and see if anyone can help me.
Here goes pin cab runs 32 inch for the playfield and 26 inch for the backglass.
video card is 9600GT all running on hyperpin with vp and fp tables, when you select a table in hyperpin the back monitor and the playfield monitor pictures go to half size when the table loads then back again after a few seconds, is there anyway to stop this from happening ?

[BadBoyBill]

What resolutions are you running at?

[bossgp]

1360x768 playfield and backglass 1280x1024 both 32 bit 60 hz

[BadBoyBill]

is hp set to these resolutions also?

[bossgp]

Thanks BBB In hyperpin in the settings.ini file I found the backglass size 1280 x1024 and yes that is the same as mine, but where to find the playfield size ?
All this is pretty funny because I never had this issue before I started using vp tables, fact is they are newer and much more fun to play so that is why it's an issue for me now.

[BadBoyBill]

Well are you using the tables from our torrent or are you using the 16:9 span tables?

[bossgp]

using ones from torrent, not spanning using dualview

[BadBoyBill]

I think it might be because of the resolution your running the playfield at, try different (higher) resolutions to see what happens, also make sure your monitors are set up where one of the monitors is either to the left or right of the playfield monitor.