boogies2
08-02-2010, 05:38 PM
I built this quite a while back, and never annouced here, until now....
Specs are:
AMD 5600+ X2
2 gb DDR 2 @ 800 mhz
nVidia 9800 gtx
Happ Controls, buttons, and 3" lighted trackball.
ipac interface
For the cabinet woodworking alone:
Approx time was 40 hours on control panel alone (had to redo twice), and the rest took about another 40 hours.
PC Hardware:
Speakers, Controller, was a few hours.
PC portion was about an hour.
Software:
Countless hours.
Most artwork was done by Mamemarquees com
I was first turned on to hyperpin for my latest build - the e-pin cab, and I'm now going back to my arcade and putting this AWESOME hyperspin software and I'll do another video once I get done with a few more emulators with hyperspin.
http://www.youtube.com/watch?v=gt5mWeXIdvs
Specs are:
AMD 5600+ X2
2 gb DDR 2 @ 800 mhz
nVidia 9800 gtx
Happ Controls, buttons, and 3" lighted trackball.
ipac interface
For the cabinet woodworking alone:
Approx time was 40 hours on control panel alone (had to redo twice), and the rest took about another 40 hours.
PC Hardware:
Speakers, Controller, was a few hours.
PC portion was about an hour.
Software:
Countless hours.
Most artwork was done by Mamemarquees com
I was first turned on to hyperpin for my latest build - the e-pin cab, and I'm now going back to my arcade and putting this AWESOME hyperspin software and I'll do another video once I get done with a few more emulators with hyperspin.
http://www.youtube.com/watch?v=gt5mWeXIdvs